Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...
To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...
Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card 2. Make sure your devi...
In order to enable the PgUp and PgDn function on your remote controller for the PX701-4K projector, please follow the instruction below: Besides your video cable (HDMI), please connect an additional USB cable from the back of the PX701-4K projector to your PC/Laptop. Change the control method to USB by entering your OSD menu -> System ...
Install the wall mount using the template, mount the projector for alignment, and set up the Laser Curtain module for interactive touch capabilities. Step-by-Step Instructions: Wall Layout: Use the included [Installation Template] to mark the drilling holes on the wall. Ensure the center line matches your projection surface's center. ...
ViewSonic will offer security update support to the following consumer projector products in compliance with the UK’s Consumer Connectable Product Security Regime and the Australian Cyber Security Act 2024 until the dates specified below. Product End of Support PX749-4K/ VS19349/ CPB414K/ HC4K41/ T4K41/ K414K/ V414K/ PX749-4KE/ PX74...
The USB Type-C port on your device must support DP Alt mode (DisplayPort Alternative Mode on USB-C). USB Type-C refers to the connector type, not the capability of the port itself, and please note that not all USB Type-C ports support video output (Video over USB Type-C). USB Type-C ports with any of the following symbols nearby will be...
For wireless casting via PJ-WPD-700, it's necessary to connect to an USB-C port of laptop/desktop which supports DP Alt mode (DisplayPort Alternative Mode on USB-C). USB Type C refers to the connector type, but not the capability of the port itself. Also, not all USB Type C ports support video output (Video over USB Type C). USB-C ports...
Please follow below steps: Connect your device and projector to the same Wi-Fi network. 2. On projector, go to Home > Screen Mirroring, there is projector's device name shown at the upper right location. (e.g. "ViewSonic PJ-XXXX") 3.On your phone/tablet, do the following: iOS: Access...
The perception of clarity can differ from person to person if the result of auto-focusing is not up to the level of clarity that you wish it to achieve you could also try out manual focusing by following the instruction below: 1. Focus sensor design behavior Focus sensor in M2e is designed to trigger manual focus control center...
Contact Us