To clean the projector lens, do the following: Use a canister of compressed air to remove dust. If the lens is still not clean, use lens-cleaning paper or moisten a soft cloth with lens cleaner and gently wipe the surface. CAUTION: Never rub the lens with abrasive materials
Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...
Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...
This is normal operation. It is either a temporary cooling phase (3–5 mins) or a result of the Network Standby feature being enabled. Detailed Explanation: 1. Cooling Down Period Behavior: The fan remains on for 90 seconds to 5 minutes after pressing the power off button. Purpose: To dissipate residual heat from the lamp. Do not unplug ...
Install the wall mount using the template, mount the projector for alignment, and set up the Laser Curtain module for interactive touch capabilities. Step-by-Step Instructions: Wall Layout: Use the included [Installation Template] to mark the drilling holes on the wall. Ensure the center line matches your projection surface's center. ...
1. Ensure that your monitor has built-in speakers. You can check it on Product's website page -> Specification -> Audio. 2. Check the cable connection: a. Make sure the connection is secured. b. Re-plug or try another HDMI (Premium) certificated cable in direct connection. c. If using a VGA cable, ensure the audio cable is connected ...
ViewSonic will offer security update support to the following consumer projector products in compliance with the UK’s Consumer Connectable Product Security Regime and the Australian Cyber Security Act 2024 until the dates specified below. Product End of Support PX749-4K/ VS19349/ CPB414K/ HC4K41/ T4K41/ K414K/ V414K/ PX749-4KE/ PX74...
The USB Type-C port on your device must support DP Alt mode (DisplayPort Alternative Mode on USB-C). USB Type-C refers to the connector type, not the capability of the port itself, and please note that not all USB Type-C ports support video output (Video over USB Type-C). USB Type-C ports with any of the following symbols nearby will be...
For wireless casting via PJ-WPD-700, it's necessary to connect to an USB-C port of laptop/desktop which supports DP Alt mode (DisplayPort Alternative Mode on USB-C). USB Type C refers to the connector type, but not the capability of the port itself. Also, not all USB Type C ports support video output (Video over USB Type C). USB-C ports...
Please follow below steps: Connect your device and projector to the same Wi-Fi network. 2. On projector, go to Home > Screen Mirroring, there is projector's device name shown at the upper right location. (e.g. "ViewSonic PJ-XXXX") 3.On your phone/tablet, do the following: iOS: Access...
Contact Us