ViewSonic XG2401/XG2402/XG2701/XG3202-C can support the resolution 1920x1080@144Hz in HDMI. However, to enable 1920x1080@144Hz, there'll be some requirements except for the monitor. 1. Graphics card/Laptop: Must support HDMI 1.4 output with 340MHz pixel clock or HDMI 2.0 output capability. 2. HDMI cable: It's suggested to connect...
This is an indicator about power consumption ratio which is affected by some OSD settings change, ex. ECO mode and Brightness. Here's a matrix table about ECO mode and power consumption ratio. ECO mode Power consumption ratio Standard 100% Optimize 85% Conserve 70%
1. Connect the USB cable to the monitors USB Type B port on the back of the monitor and attach the other end of the cable to an available USB port on the computer. Allow 10-15 seconds for the computer to recognize the external webcam. Please do remember to connect the video signal cable between monitor and computer. NOTE: This method will ...
When resolution is set in native resolution (1:1), both Sharpness and Overscan option in OSD will be grey out.
You can refer to this video. 1. Lay the monitor unit face down on a flat surface, using the soft bag received or a soft material to avoid damaging the screen. 2. Insert and align the Neck of the stand (Do NOT attach the base to the neck) into the stand slot on the display. 3. Firmly push the neck into the slot while securing t...
MPRT and FreeSync are incompatible with each other because: MPRT will KEEP the refresh rate at a high and constant point. FreeSync will CHANGE the refresh rate continuously in a range between the minimum and maximum rate of the monitor. Therefore, all ViewSonic monitors that have MPRT(1ms) and FreeSync are not able to have both functio...
No, as Linux system should automatically identify and recognize the monitor.
MacOS does not require monitor drivers when using a ViewSonic monitor. The MacOS will automatically read the EDID information stored in the monitor and use the system information/profiler utility to detect the monitor’s specifications and capabilities. If you can not get native resolution or refresh rate on the monitor: Please check if ...
To output: 1.1080p content at 144Hz, you will need either a dual-link DVI, a DisplayPort, or an HDMI 1.3 or higher cable. 2. 1440p at 144Hz, you will need at least an HDMI 2.0 or a DisplayPort 1.2 cable. 3.4K at 144Hz, you will need a HDMI 2.1 or a DisplayPort 1.4 cable which can carry 120Hz signal without compression.
Response time option can be selected under different View Mode. Viewmode => Standard => Response time => Standard / Advanced / Ultra fast Viewmode => Game => Response time => Standard / Advanced / Ultra fast In both cases, while selecting the “Advanced” or even “Ultra fast”, it brings a very strong ghosting effect and blurry while scro...