During servicing, where do I place the de-installed LED module(s) for a DVLED Display?

Answer: LED modules should be placed on a flat, anti-static, padded surface when swapping LED Modules. If there is no opening for the connectors, module should be placed bead-side down to prevent connector damage. Product Safety The following components on the LED module can be damaged if not handled well:  LED Bead damage diagram ...

How do I properly store DVLED Display LED module(s)?

LED Modules (either damaged and/or undamaged) should be stored in module boxes according to the following packaging steps when not mounted on the display. If there is a shortage of module boxes, please contact Customer Service. Please refer to the Proper LED Module Packaging SOP for full details. Solution Obtain the Module Box(s). Eac...

How do I properly package DVLED Display LED module(s) for shipping?

Before LED Modules are shipped out, they must be packaged in a specialty Module Box according to the following packaging steps specifically designed to hold LED modules. Please refer to the Proper LED Module Packaging SOP for full details. Solution Obtain the Module Box(s). Each module box should be able to hold 4 LED modules.  NOTE: ...

Can ViewSonic projector remote control work on DVLED Displays?

Answer: Yes. The remote controls that operate a ViewSonic projector will also work on a DVLED Display.

How many Receiving Cards and Transfer Boards are there on a DVLED Display?

The number of Receiving Cards and Transfer Boards will vary by model. However, Since a 1x Receiving Card is required to connect with 1x Transfer Card, the number of Receiving Cards will be consistent with the number of Transfer Boards. Solution Complete information can be found in the "LED Display Product Engineering Specification" docu...

How do I calibrate overall brightness on my DVLED Display?

After replacement of a particular LED module, brightness may be slightly different than that of other modules. At this point, manual calibration is required. In order to troubleshoot this problem, the following procedure can be followed: Solution Step 1: Use the USB B-to-A cable to connect the display to the computer. Step 2: A...

What is the Bracket installation order of the DVLED Floor Stand configuration?

The Bracket installation order varies from the Wall-mount configuration. Please follow the steps in the respective order for the Floor Stand configuration: Bottom cross beam installed to the left and right supports. Top cross beam installed to the left and right supports. Original mounting bracket removed from the top and reattached to the ...

What is the Bracket installation order of the DVLED Wall-mount configuration?

The Bracket installation order varies from the Floor Stand configuration. Please follow the steps in the respective order for the Wall-mount configuration: Appropriate location and center point found for installation (e.g. upper bracket mounted at least two meters above the ground for a 135" LED display; for other display sizes, check corresp...

How do I install a DVLED display with a Floor Stand configuration?

Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Floor Stand Step 2: Install the System Control Box onto the Floor Stand Step 3: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 4: Install the LED Modules onto the Cabin...

How do I install a DVLED display with a Wall-mount configuration?

Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Wall-mount brackets Step 2: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 3: Install the System Control Box onto the Floor Stand Step 4: Install the LED Modules onto t...

Direct View LED Display Support

General Questions

Contact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.