LED monitors produced after 2020 have FreeSync enabled by default. For LED monitors manufactured before 2020, please refer to the following instructions to enable FreeSync. To use AMD Freesync, there're some requirement with graphics cards, graphics drivers and certified monitors. 1. A compatible GPU with a DisplayPort connection. ...
PlayStation 5 and Xbox Series X/S consoles support video output up to 120 Hz. Follow the instructions below to configure 120 Hz output. <PlayStation 5> 1. Open "Settings". 2. Select "Screen and Video". 3. Select "Enable 120 Hz Output" under "Video Output". 4. Select "Automatic" in the pop-up menu. 5. Return...
It is suggested to use greater than 6mm diameter pen tip. Stylus/ Passive pen with conductive cloth material will work with all ViewSonic’s Projected Capacitive touch monitors (TD1630/TD2230/TD2430, TD2455/TD1655, TD2760). Pen tip with 8mm diameter is better for TD2230. Note: TD2455 and TD1655 stylus/passive pen (Included in ...
To enable 180Hz refresh rate on your monitor, you need to turn on Overclocking in the monitor's On-Screen Display (OSD) Menu. After turning on Overclocking, you then can set the refresh rate to 180 Hz under your computer's “Display” settings. For example, in Windows go to Settings > System > Display > Advanced display to set the refr...
You can navigate to manual Image adjust on OSD menu. Select Overclocking -> 165Hz.
Can I Calibrate my sRGB or AdobeRGB monitor’s Luminance value below 80cd/m^2? NO
Why does brightness go down on VP2785-4K after calibration? Because on VP2785-4K, Energy saving is set to ON by default for power saving. Please turn off the Energy saving to OFF and proceed with calibration.
VG2440V supports all versions of Linux OS.
ViewSonic FreeSync monitors support GeForce Driver G-Sync Enable-Ready. *Legal Disclaimer for GeForce Driver G-Sync Enable-Ready: Our product follows the Adaptive Sync technology standard adopted by the Video Electronics Standards Association (“VESA”). Our product is compatible with and certified by AMD for AMD’s FreeSync Te...
The VG2756-4K (via USB-C) by default can display 4K 60Hz, and the OSD setting for "USB 3.2" is Off. If the user turns "USB 3.2" On, then a USB-C connection can only display 4K 30Hz. There's not enough bandwidth for USB 3.2 speeds when connected via USB-C to output 4K 60Hz. This situation will only happen on a USB-C connection. If u...