Analog extension cables, adapters, docking stations and longer cables may be prone to generate ghosting, lines, double images, or poor focus. The improper shielding of the extension cables will cause a shadowing or ghosting effect due to mismatch of the input impedance between the video source, the video cable, and the projector. Please use th...
1. Press the menu button on the projector or the remote control and then navigate to the Advanced Settings. 2. Select to restore factory default settings. Note: Some models may have the reset option in a slightly different location. Please check the user guide for specific steps.
There are some possible reasons caused, please check below first: <Airflow> Air Flow is important for cooling: Please make sure the intake and exhaust vents are free from obstruction. Make sure the projector is not enclosed or right against a wall - it needs ventilation space. Don’t place the projector on top of other electr...
When a digital signal is connected (e.g. HDMI, DisplayPort, DVI), there are certain options greyed out in OSD menu as preset settings that cannot be changed. Those greyed out settings will be available when an analog signal (e.g. VGA) is connected.
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.
For Models: PA/PG/PX Series “Power On” and “Power Off” are separated as two (2) different buttons on the remote control. This is different from the PJD series.
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
Each product has its own list of compatible video, audio and image formats. The best way to know what file type is specifically supported by your product is to look in the user guide for your particular model.
Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/
Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...