There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

What to do if there is no sound from the projector’s speakers when connected the PC/laptop to projector?

1. Ensure that your monitor has built-in speakers. You can check it on Product's website page -> Specification -> Audio.   2. Check the cable connection: a. Make sure the connection is secured.  b. Re-plug or try another HDMI (Premium) certificated cable in direct connection. c. If using a VGA cable, ensure the audio cable is connected ...

How to fix the keystone effect (distorted image) on a projector?

Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust:   Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...

How to change the projector image orientation

Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...

How to change the projector image orientation (Flip or Mirror image)?

Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below.     a. 3D ready projector     b. 3D Blu-Ray player     c. 3D content     d. Active 3D glasses 144Hz     e. HDMI Premium Certificate cable   2. Here is the playback process below.       a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable.       b. T...

Why does my projector automatically shut down during use?

Auto-shutdown is typically triggered by overheating protection. Ensure proper ventilation, clean the dust filters, and enable "High Altitude Mode" if necessary. Check LED Indicators: If the Temp light is red or flashing after shutdown, the projector has overheated. Improve Airflow: Keep at least 50cm of clear space around intake an...

The image is out of focus

Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if  the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...

Android mobile phones are unable to mirror cast via Google Home App.

Recently we've noticed an incompatibility issue between some ViewSonic smart projectors and Google Home App with the latest update. Some users might not see ViewSonic projectors on the device list when trying to mirror cast their Android mobile phone to ViewSonic projectors via Google Home App.  We are aware of this issue and currently workin...

How to enable the remote controller PgUp and PgDn functions?

In order to enable the PgUp and PgDn function on your remote controller for the PX701-4K projector, please follow the instruction below: Besides your video cable (HDMI), please connect an additional USB cable from the back of the PX701-4K projector to your PC/Laptop. Change the control method to USB by entering your OSD menu -> System ...