Skip to main content

How to purchase a lens for a projector

Or browse to your projector model in the Projector Accessories section of the ViewSonic Store.  If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below.     a. 3D ready projector     b. 3D Blu-Ray player     c. 3D content     d. Active 3D glasses 144Hz     e. HDMI Premium Certificate cable   2. Here is the playback process below.       a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable.       b. T...

How to solve “Out of range” when connecting PC/laptop to a projector?

Please refer to this FAQ.

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

How to fix the keystone effect (distorted image) on a projector?

Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust:   Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...

How to change the projector image orientation (Flip or Mirror image)?

Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...

How to change the projector image orientation

Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...

What to do if the projector won't turn on or has no power?

Check all cable connections, verify the LED indicator on the AC adapter, and test a different wall outlet. Verify Connections: Ensure the power cord is firmly seated in the AC adapter "brick" and the plug is fully inserted into the wall outlet. Check Adapter LED: Look for a small light on the adapter unit. LED On: The adapter is re...

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

Projector Підтримка

General Questions Technical Documents vRemote Tips & Tricks

Загальні запитиЗв'яжіться з нами

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.