After replacement of a particular LED module, brightness may be slightly different than that of other modules. At this point, manual calibration is required. In order to troubleshoot this problem, the following procedure can be followed: Solution Step 1: Use the USB B-to-A cable to connect the display to the computer. Step 2: A...
The Bracket installation order varies from the Wall-mount configuration. Please follow the steps in the respective order for the Floor Stand configuration: Bottom cross beam installed to the left and right supports. Top cross beam installed to the left and right supports. Original mounting bracket removed from the top and reattached to the ...
The Bracket installation order varies from the Floor Stand configuration. Please follow the steps in the respective order for the Wall-mount configuration: Appropriate location and center point found for installation (e.g. upper bracket mounted at least two meters above the ground for a 135" LED display; for other display sizes, check corresp...
Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Floor Stand Step 2: Install the System Control Box onto the Floor Stand Step 3: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 4: Install the LED Modules onto the Cabin...
Please refer to this link before beginning any Direct View LED Display installs. Solution Step 1: Install the Wall-mount brackets Step 2: Install the Cabinets onto the Floor Stand, connect the System Control Box to the Cabinets Step 3: Install the System Control Box onto the Floor Stand Step 4: Install the LED Modules onto t...
Solution Step 1: Please contact customer service staff to obtain the mandatory firmware update file(s) Step 2: Copy the files to the outermost directory of the USB Step 3: Turn off the power of the LED display and plug in the USB Step 4: Press the power button to turn on the display, and immediately press the Menu butto...
Answer: If the LED display does not work, but the power supply and other equipment checks are working, it may be caused by a firmware conflict. Please perform mandatory firmware update under this circumstance.
The Direct View LED Display can be operated by either: 1) the Remote, 2) the Keyboard, 3) or RS232 For further details, please refer to this link and select the appropriate model to view the respective User Guide.
Solution Please refer to the following diagram below. This information can also be found in each Direct View LED Display's respective User Guide. Recommended Links "Why is the DVLED Display remote control having trouble with sensitivity or not working?" "How do I lock the remote control for my DVLED Display?"
When you find that the edge brightness of the LED module is different from that of the adjacent modules, the following procedure below can be followed in order to resolve the problem. Solution Step 1: Use the USB B-to-A cable and HDMI cable to connect the monitor to the computer, and switch the monitor's input source to HDMI. Step...