On some projector models, the fan will remain on after the unit has been shut down and in standby mode. This is normal operation for any model with the network feature that had been enabled. The feature can be disabled by selecting Menu>Option>Network > Off. If the Network feature is enabled then expect the fan to remain on at a lower speed w...
Open the projector Menu and go to System Setting: Basic> Projector Position and choose one of the four available options: Front Table Rear Table Ceiling Front Ceiling
1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...
Usually this is related to unmatched output resolution setting and content. For example, setting 720P resolution output to a 4K projector or playing a 720P video on a 4K projector in full screen would cause pixelated. Please make sure to set recommended resolution by referring to this FAQ.
There are some possible reasons caused, please check below first: <Airflow> Air Flow is important for cooling: Please make sure the intake and exhaust vents are free from obstruction. Make sure the projector is not enclosed or right against a wall - it needs ventilation space. Don’t place the projector on top of other electr...
To clean the projector lens, do the following: Apply a non-abrasive camera lens cleaner to a soft, lint-free cloth. Do NOT spray the cleaner directly onto the lens. Avoid abrasive cleaners/solvent, as they may permanently damage the lens. In a circular motion gently wipe the lens clean. Replace lens cap if projector is not to be used.
Make sure the signal cable is securely connected. 2.Try another video input source or cable or device to crosscheck. 3.Check the current resolution and refresh rate set in the graphic card or video source is compatible with the projector. You can refer to refresh rate setting video. How t...
Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...
Projectors may shut off for a couple different reasons. If the projector over heats, check to see if there is enough ventilation for air to be circulated around the unit. Make sure fans are running and that there is no obstruction. Let it cool, clear obstructions and check fans when turning the unit back on. After market lamps may cause a...
Verify adapter plugged into a wall outlet Make sure the AC adapter is firmly and securely plugged into the wall outlet. Although it may sound obvious, the adapter can become loose without even knowing. If it's not plugged in all the way, it can make it seem like the adapter is not working, but it may just not be getting power from the wall...