Skip to main content

Should I install Windows 10 drivers for my monitor?

ViewSonic plug and play monitors do not require a proprietary Windows 10 driver to be installed.   Instead, Windows 10 will automatically read the EDID information stored in the monitor and install Generic PNP Monitor drivers to enable its full resolution capabilities.   The only difference is you will see monitor model name in Device Manag...

How to set maximum resolution for my monitor?

Please refer to this FAQ section 1 and set to recommended display resolution.

How to solve the problem with my monitor turning off automatically?

Automatic shutdowns are often caused by power-saving settings, inconsistent power supply, or signal loss. Please check the OSD timer settings first. Troubleshooting Steps: Check OSD Menu Settings (Most Common): Navigate to the [Setup Menu]. Locate [Auto Power Off] or [Sleep Timer] and ensure they are set to [Off]. Also, verify ...

How to check graphics card drivers in Windows?

1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.

What to do when the screen image is pixelated or blurry?

Blurry images are typically caused by an incorrect resolution or scaling setting. Ensure your computer is set to the monitor's Native Resolution. Troubleshooting Steps: Set to Native Resolution: Windows: Right-click desktop > [Display settings] > [Display resolution]. Choose the one labeled (Recommended). macOS: Go to [System Sett...

What to do if there is flickering image with my monitor?

Check the monitor: Please do memory recall. Please refer to this FAQ Check device setting: Please check and set to recommended refresh rate.  You can refer to this video. https://www.youtube.com/watch?v=sAkbjPiLNcE   If possible, please connect monitor to another device with different input.   If above doesn’t help, please contact ViewSo...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion.   1.Adjust setting on the PC/laptop:   (1)Set native resolution of monitor in your PC/laptop's Display settings.   (2)Change Scaling in Display settings.   Use the graphic card software to change ...

How to set power lock and menu lock?

On some monitors, there is a power button lock that locks the power and power button in the ON position.  There is also a menu lock feature which can lock and unlock the OSD (On-Screen Display) Menu.  Power Lock: To lock the Power Button press and hold both the [1] button and the down arrow button for 10 seconds.  OSD Lock: ...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

LED Monitor Support

General Questions ColorPro™ (VP series)

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.