How to clean LCD display?

General Precautions Make sure the monitor is turned off and the power cable is unplugged from the power outlet. Never spray or pour any liquid directly onto the screen or case. Doing so could damage your monitor. Dust or hard materials may scratch the screen. Please make sure the cleaning cloth is free of any debris. Clean and dry the m...

Where to find serial number of the monitor?

The serial number can usually be found on the back or bottom of your product and is either 10 or 12 digits long. The serial number can also be found on the original box of the unit.

Should I install Windows 10 drivers for my monitor?

ViewSonic plug and play monitors do not require a proprietary Windows 10 driver to be installed.   Instead, Windows 10 will automatically read the EDID information stored in the monitor and install Generic PNP Monitor drivers to enable its full resolution capabilities.   The only difference is you will see monitor model name in Device Manag...

How to set power lock and menu lock?

On some monitors, there is a power button lock that locks the power and power button in the ON position.  There is also a menu lock feature which can lock and unlock the OSD (On-Screen Display) Menu.  Power Lock: To lock the Power Button press and hold both the [1] button and the down arrow button for 10 seconds.  OSD Lock: ...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

Why does my TD2220 randomly receive touch signal and respond accordingly while exposed to sunlight?

TD2220 is an optical touch monitor which uses two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the sensor...

Why can't I choose Contrast or Brightness?

Certain preset modes (ViewMode) are factory-calibrated for specific visual tasks and will lock parameters to maintain optimal performance. Switch to [Standard] mode to regain manual control. Step-by-Step Instructions: Press the [Menu] button (located on the back or bottom of the monitor) to open the OSD menu. Navigate to the [ViewMode...

How to enable AMD FreeSync?

LED monitors produced after 2020 have FreeSync enabled by default. For LED monitors manufactured before 2020, please refer to the following instructions to enable FreeSync. To use AMD Freesync, there're some requirement with graphics cards, graphics drivers and certified monitors. 1. A compatible GPU with a DisplayPort connection. ...

How to output video at 120 Hz from PS5 or Xbox Series X/S to ViewSonic monitors.

PlayStation 5 and Xbox Series X/S consoles support video output up to 120 Hz. Follow the instructions below to configure 120 Hz output. <PlayStation 5> 1. Open "Settings". 2. Select "Screen and Video". 3. Select "Enable 120 Hz Output" under "Video Output". 4. Select "Automatic" in the pop-up menu. 5. Return...

What Kind of Stylus conductive pen is compatible with ViewSonic Touch Monitors?

It is suggested to use greater than 6mm diameter pen tip.  Stylus/ Passive pen with conductive cloth material will work with all ViewSonic’s Projected Capacitive touch monitors (TD1630/TD2230/TD2430, TD2455/TD1655, TD2760).    Pen tip with 8mm diameter is better for TD2230.   Note: TD2455 and TD1655 stylus/passive pen (Included in ...