Skip to main content

The image is out of focus

Make sure that you have set it to its native resolution. Check the user guide to determine what the native resolution of the display is and set it to the native resolution if  the video source that is being used can support it. Digital signals (HDMI, DisplayPort) normally produce sharper images. If you are using a VGA or analog signal try to s...

How to change the projector image orientation (Flip or Mirror image)?

Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...

How do I connect external speaker(s) to my projector?

1.Wired connection:   1.1 via 3.5mm audio out:       If the projector is equipped with a 3.5 mm audio out mini jack, usually it is  green and marked as          Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output        purpose.     1.2 via S/PDIF:        If the model is equipped with S/PDIF por...

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage.   2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

How to change the projector lamp in a projector?

The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page.   <Note> It is recommended that you use an authentic ViewSonic replacement lamp.  

How to change the projector image orientation

Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...

Purchased replacement parts

Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/

How to fix shadows, ghosting, or double images on the projector screen?

Image artifacts are often caused by poor cable quality or signal interference. Use high-quality cables and avoid using excessive adapters. Use Bundled Cables: Test using the [original video cable] provided with the product. Remove Intermediate Devices: Disconnect any [docking stations], [adapters], or [video splitters]. Connect the ...

How to mirror iPhone or iPad screen to the projector? (Wired Connection Guide)

Use a USB-C cable or an appropriate HDMI adapter for a stable, low-latency wired connection. USB-C Direct Connection (Recommended): Use a USB-C cable that supports video transmission (using the cable provided with the projector is highly recommended). Connect your device directly to the projector's [USB-C] port. Select [USB-C] a...

Why a black border on the top/bottom or sides of the image from the projector?

Please check below:   1.Plesae refer to the user guide and adjust Aspect ratio with example below.   2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.

Projector Support

General Questions Technical Documents vRemote Tips & Tricks

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.