How to purchase a lens for a projector

Or browse to your projector model in the Projector Accessories section of the ViewSonic Store.  If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

There are issues connecting an external monitor to a computer/projector

If the external monitor/ projector is not automatically detected and displaying an image, you will need to use a function key to enable or activate the function. Laptop manufacturers have different methods to activate an external monitor. Refer to the laptop's user guide/manual or the manufacturer for instructions to activate the video port for...

Why the image is pixelated from my projector?

Usually this is related to unmatched output resolution setting and content.  For example, setting 720P resolution output to a 4K projector or playing a 720P video on a 4K projector in full screen would cause pixelated.   Please make sure to set recommended resolution by referring to this FAQ.

How to solve “Out of range” when connecting PC/laptop to a projector?

Please refer to this FAQ.

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

How to change the projector image orientation

Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...

What to do if the projector won't turn on or has no power?

Check all cable connections, verify the LED indicator on the AC adapter, and test a different wall outlet. Verify Connections: Ensure the power cord is firmly seated in the AC adapter "brick" and the plug is fully inserted into the wall outlet. Check Adapter LED: Look for a small light on the adapter unit. LED On: The adapter is re...