Commercial DisplaySupport - ViewSonic Global

The image is distorted from NMP-302w HDMI out, how can I do?

You can refer below steps to check the issue. 1. To reset the NMP-302w. 2. To replace the HDMI(extension) cable. If above steps can't solve the issue, it will be NMP-302w mainboard issue, you need to replace NMP-302w.

How to check whether vSignage can sync with others players and see the campaign?

If you are unable to sync the contents, there may be a connection issue. To verify if the admin is sync with the player, there is a JSON API in vSignage. 1. First make sure your windows firewall setting has allow vSigange to access. 2. Please use this API to check if source player see any other players and campaign. Open the Chrome br...

How to install Signage Manager License with CDM4900R/ CDM4300R/ CDM5500R/ CDM5500T?

1. Download the attached license file. 2. Select the correct Time Zone. 3. Please follow the below procedures to install the Signage Manager license: license URL:https://support.viewsonic.com/helpdesk/attachments/33040907670

How to update F/W on EP3220/4320/5520?

Upgrade under the factory menu Copy MstarUpgrade.bin in USB and Insert U disk to the USB port Press Input menu and then press 2 5 8 0 to activate factory menu (Fig. 1) Move to “Upgrade Main” item and press OK button to confirm. (Fig. 2) Select “Confirm” to confirm the upgrade (Fig. 3), the system will automatically reboot and start the up...

How can I add other widgets to the Signage manager software?

You can refer below steps to use other widgets.

Which network ports should be opened for Signage Manager and media players?

To ensure Signage Manager can discover and control players over a Local Area Network (LAN), please ensure that TCP 80, 8080, 443, and UDP 1900 are opened in your firewall settings. Port Configuration Table: Port TCP UDP Description 80 TCP Hypertext Transfer Protocol (HTTP), main communication port with legacy play...

How to prevent image quality loss when exporting from Signage Manager?

While editing content with Signage Manager, it will compress and save photo in lower quality. Please follow below procedures to replace the photo. 1. After finishing editing in Signage Manager, choosing “Export to USB”. 2. Open “File Explorer” and locate USB drive in SMIL/media folder. 3. Copy original photos to this folder and...

How to get back to the dashboard while content is playing via vSignage?

There are two methods to get back to the dashboard. 1. Press up button on the remote control to go to the dashboard 2. Connected to a mouse, directly press and hold anyone of the corner area, after successfully triggering the countdown, the corner area will flash in reverse (as shown in the figure). It will exit after ten seconds.

Does the EP5520 support WPA2-Enterprise authentication and certificate installation?

Yes. The capability for Enterprise authentication depends on the hardware specifications of the installed Wi-Fi module/dongle and its firmware compatibility. Instructions & Steps: Hardware Verification: Supported Wi-Fi security protocols are dictated by the Wi-Fi Module/Dongle. Please ensure your module supports 802.1X / WPA2-Enterprise ...

ViewSonic CDE30 Series Power Save Modes: Which Mode Should I Use?

ViewSonic CDE30 Series power save modes: Which mode should i use? There are four Power Save modes to choose from and knowing which one to use depends on the application. For this scenario we will cover digital signage, information and monitoring systems and meeting rooms where always-on, wake up on active signal and fast boot time is a must...