What is the LED module specs for DVLED Displays?

LED module specs for DVLED Displays will vary by model. Please refer to the following table below:

What are the main installation differences between Wall-mount and Floor Stand setups for DVLED Displays?

Wall-mount Upper and lower bracket locations aligned and mounted first Upper bracket screw holes on the bottom Cabinets are installed before system control box is installed After upper and lower brackets installed, Cabinet "C" installed in the center position first. Next, Cabinets "B", "D", "E", "A" installed in this respective order...

What questions do I need to consider before installing my DVLED Display?

Where will the product be installed? Is the power outlet separated and not shared with any other appliance? Will the power cable be hidden behind the Direct View LED (not seen), or will it be visible (wire will be seen)? What type of wall will the unit be mounted to? Is the wall composed of block, drywall, plaster, wood or metal studs? Do...

What are the Installation Tools required to install my DVLED Display?

The recommended tools (unless otherwise stated) needed to install a dvLED Display is as shown below: Self-leveling laser level Stud sensor/finder - multi-depth/material (2) 8’ ladder Anti-static gloves (required) 3/8” hammer drill/driver ¼” impact driver Pilot point drill bit set for metal Metric ball-end hex key set Impact-ready bit ...

Why can't RS232 be used to Power on/off the DVLED Display while in Standby Mode?

Currently, RS232 cannot Power on/off a DVLED display while in Sleep Mode. Check the On-Screen Display (OSD) settings to see if the Standby Mode is set to Sleep Mode.   Solution 1. To Power on/off a DVLED display using RS232, switch the Standby Mode in the On-Screen Display (OSD) settings to Hibernate Mode.   2. The DVLED disp...