How to change the projector image orientation

Open the projector Menu and go to System Setting: Basic> Projector Position and choose one of the four available options: Front Table Rear Table Ceiling Front Ceiling

The projector fan stays on after the unit has been turned off

On some projector models, the fan will remain on after the unit has been shut down and in standby mode. This is normal operation for any model with the network feature that had been enabled. The feature can be disabled by selecting Menu>Option>Network > Off. If the Network feature is enabled then expect the fan to remain on at a lower speed w...

The AC adapter for the projector does not work

Verify adapter plugged into a wall outlet Make sure the AC adapter is firmly and securely plugged into the wall outlet.  Although it may sound obvious, the adapter can become loose without even knowing.  If it's not plugged in all the way, it can make it seem like the adapter is not working, but it may just not be getting power from the wall...

Projector turns on initially but then cycles off

Projectors may shut off for a couple different reasons. If the projector over heats, check to see if there is enough ventilation for air to be circulated around the unit. Make sure fans are running and that there is no obstruction. Let it cool, clear obstructions and check fans when turning the unit back on. After market lamps may cause a...

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below.     a. 3D ready projector     b. 3D Blu-Ray player     c. 3D content     d. Active 3D glasses 144Hz     e. HDMI Premium Certificate cable   2. Here is the playback process below.       a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable.       b. T...

What to do if I can't mirror my screen after I updated the iOS version to iOS14?

Due to iOS14 compatibility issues, please follow below table for solution.   Model Solution X100-4K Install EAirPlay.apk and follow instruction X10-4K Update FW to V1.13 via OTA M2 Update FW to V1.0 via OTA M1+_G2/M1+_V Update FW to V1.04 via OTA M1 mini plus Update FW to V1.02 via OTA SOP URL: https://support.viewsonic.com/hel...

How to do when my screen doesn’t display native resolution after Windows 10 update?

Windows update may cause some issues with screen resolution setting being lost, Please follow below steps to change the resolution of the screen and check: Type Change screen resolution in the Search box from the desktop  and click   Change screen resolution of the display.   Under Display Resolution select Recommended resolution. A wi...

What to do if remote control does not work properly?

  Please do the following check: Make sure there are no obstructions in the way of the IR receiver on the device. Move closer to the receiver (within 23 feet) or change the angle (within 30 degrees) to the receiver. Replace the batteries. Even if lights on the remote control are on, weak batteries may still cause the remote control to oper...

What to do if the image shows keystone effect from the projector?

When you see below situation, please follow below instructions to adjust:   If the projector supports Auto Keystone or Vertical keystone, please try to turn on or manually adjust by referring to user guide. If possible, put the projector on the flat surface and make sure projector lens and screen are in a 90-degree angle.  

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

Contact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.