In normal operating conditions, there might be normal electric current sound came monitor which should not impact on your usage. If this did not occur in the past but appeared recently, please contact ViewSonic service center.
These models are optical touch monitors which use two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the se...
ViewSonic plug and play monitors do not require a proprietary Windows 10 driver to be installed. Instead, Windows 10 will automatically read the EDID information stored in the monitor and install Generic PNP Monitor drivers to enable its full resolution capabilities. The only difference is you will see monitor model name in Device Manag...
If the monitor turns on briefly, then turns off, check the following: Make sure the power cable is securely connected. Turn off the monitor, unplug the power cable for 15 seconds and plug the power cable back then turn on. Check the video cable and make sure it is connected on both ends securely. Reset the factory default ...
1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.
No, as Linux system should automatically identify and recognize the monitor.
If the image doesn’t fit the screen, please do the following: 1.Check the applied resolution to make sure that they match the settings recommended in the user guide. To check the resolution in Windows: (1)Settings > Display > Click on the display that user wants to change the setting (2)Change the display resolution for ...
Check the monitor: Please do memory recall. Please refer to this FAQ Check device setting: Please check and set to recommended refresh rate. You can refer to this video. https://www.youtube.com/watch?v=sAkbjPiLNcE If possible, please connect monitor to another device with different input. If above doesn’t help, please contact ViewSo...
The serial number can usually be found on the back or bottom of your product and is either 10 or 12 digits long. The serial number can also be found on the original box of the unit.
If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion. 1.Adjust setting on the PC/laptop: (1)Set native resolution of monitor in your PC/laptop's Display settings. (2)Change Scaling in Display settings. Use the graphic card software to change ...