ProjectorSupport - ViewSonic Australia

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below. a. 3D ready projector b. 3D Blu-Ray player c. 3D content d. Active 3D glasses 144Hz e. HDMI Premium Certificate cable 2. Here is the playback process below. a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable. b. T...

How to make the screen fit my projector's display area?

Please refer to this FAQ: How to solve the overscan problem with my monitor?

How to fix shadows, ghosting, or double images on the projector screen?

Image artifacts are often caused by poor cable quality or signal interference. Use high-quality cables and avoid using excessive adapters. Use Bundled Cables: Test using the [original video cable] provided with the product. Remove Intermediate Devices: Disconnect any [docking stations], [adapters], or [video splitters]. Connect the ...

How to change the projector image orientation

Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...

Why does the projector fan stay on after the unit is turned off?

This is normal operation. It is either a temporary cooling phase (3–5 mins) or a result of the Network Standby feature being enabled. Detailed Explanation: 1. Cooling Down Period Behavior: The fan remains on for 90 seconds to 5 minutes after pressing the power off button. Purpose: To dissipate residual heat from the lamp. Do not unplug ...

How do I connect external speaker(s) to my projector?

1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...

What to do if I can't mirror my screen after I updated the iOS version to iOS14?

Due to iOS14 compatibility issues, please follow below table for solution. Model Solution X100-4K Install EAirPlay.apk and follow instruction X10-4K Update FW to V1.13 via OTA M2 Update FW to V1.0 via OTA M1+_G2/M1+_V Update FW to V1.04 via OTA M1 mini plus Update FW to V1.02 via OTA SOP URL: https://support.viewsonic.com/hel...

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.