How to check graphics card drivers in Windows?

1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.

How to solve the problem with my monitor turning off automatically?

Automatic shutdowns are often caused by power-saving settings, inconsistent power supply, or signal loss. Please check the OSD timer settings first. Troubleshooting Steps: Check OSD Menu Settings (Most Common): Navigate to the [Setup Menu]. Locate [Auto Power Off] or [Sleep Timer] and ensure they are set to [Off]. Also, verify ...

Why is my monitor emitting a high-pitched noise or buzzing sound?

Slight electronic humming is often normal (Coil Whine); however, persistent or loud noise may require environmental troubleshooting or technical support. Check Power Source: Plug the monitor directly into a wall outlet instead of a power strip to rule out electrical interference from other devices. Adjust Brightness: Try changing the b...

How to enable/disable VX3258-2KC-MHD crosshair toggle?

If you see a crosshair in the middle of your VX3258-2KC-MHD monitor’s screen, please perform the step below.                    With the monitor powered on, press the joy key downward on the back of the monitor to toggle the crosshair on or off. To bring it back up press downward on the joy key again.

Can I turn on 1ms MPRT and FreeSync at the same time?

MPRT and FreeSync are incompatible with each other because: MPRT will KEEP the refresh rate at a high and constant point. FreeSync will CHANGE the refresh rate continuously in a range between the minimum and maximum rate of the monitor.   Therefore, all ViewSonic monitors that have MPRT(1ms) and FreeSync are not able to have both functio...

What is the Native luminance of sRGB and AdobeRGB on colorbration+ ?

What is the Native luminance of sRGB and AdobeRGB on colorbration+ ?   Native Luminance of sRGB is 120cd/m^2 Native Luminance of AdobeRGB is 160cd/m^2

Why does my TD2220 randomly receive touch signal and respond accordingly while exposed to sunlight?

TD2220 is an optical touch monitor which uses two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the sensor...

Why can’t I run ViewSplit when connected to ViewSonic monitor?

Your ViewSonic monitor must be set to the Main display. To verify this please follow the steps below:     1. Right click on your desktop and select “Display Settings”.      2. Click on the display number at the top that you want to make the main display and check the “Make this my main display box” under Multiple displays.    3. If th...

How to enable AMD FreeSync?

LED monitors produced after 2020 have FreeSync enabled by default. For LED monitors manufactured before 2020, please refer to the following instructions to enable FreeSync. To use AMD Freesync, there're some requirement with graphics cards, graphics drivers and certified monitors. 1. A compatible GPU with a DisplayPort connection. ...

Why sharpness setting in OSD menu is grey out on my XG2702 and VA2719-2K-SMHD?

When resolution is set in native resolution (1:1), both Sharpness and Overscan option in OSD will be grey out.