ProjectorSupport - ViewSonic Asia Pacific

How to do when my screen doesn’t display native resolution after Windows 10 update?

Windows update may cause some issues with screen resolution setting being lost, Please follow below steps to change the resolution of the screen and check: Type Change screen resolution in the Search box from the desktop and click Change screen resolution of the display. Under Display Resolution select Recommended resolution. A wi...

How to purchase a lens for a projector

Or browse to your projector model in the Projector Accessories section of the ViewSonic Store. If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...

Purchased replacement parts

Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/

How to change the projector image orientation

Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...

How to change the projector image orientation (Flip or Mirror image)?

Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...

How do I connect external speaker(s) to my projector?

1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...

What should I do if the projector remote control is not working?

Replace the batteries and ensure there are no obstructions between the remote and the projector's IR receiver. Replace Batteries: Insert a fresh set of batteries. Low power can cause intermittent operation even if the remote’s indicator light turns on. Clear Obstructions: Ensure the [IR Receiver] on the projector is not blocked by any ...

How to mirror iPhone or iPad screen to the projector? (Wired Connection Guide)

Use a USB-C cable or an appropriate HDMI adapter for a stable, low-latency wired connection. USB-C Direct Connection (Recommended): Use a USB-C cable that supports video transmission (using the cable provided with the projector is highly recommended). Connect your device directly to the projector's [USB-C] port. Select [USB-C] a...

How to set up dual projectors on a Windows computer?

Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card 2. Make sure your devi...

How to fix the keystone effect (distorted image) on a projector?

Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...