Why is an entire column of LED Modules not on even though my DVLED Display is powered on?

DVLED Display with an entire column of unlit LED Modules.  Answer: There may be poor connection or loose wiring with the connectors from the System Control Box to the LED Module adapter board. Solution The column's most bottom LED Module will need to be removed with the Vacuum Suction Tool in order to access the connectors. ...

What is a "Customer Maintenance Notice" for dvLED displays?

Answer: The Customer Maintenance Notice is a document that should be explained to the customer on-site, immediately after dvLED installation (during or after software setup). The document contains crucial information regarding proper usage and maintenance critical to effectively extending the life cycle of the product.   Note: Full documen...

What are the power source requirement for DVLED?

Power Receptacle Type L5-30P, EU, UK, AU, CN  (may vary depending on region. double check power supply compatibility) Power Input Voltage Range 100-240 V ~ 50/60Hz Input Current 30A max @110V; 15A max@220V Leakage Current <0.25mA@240VAC Power Outlet quantity 1 (for 108", 135", 163"), 2 (for 216") *Recommended use on a singl...

What is the Cabinet installation order of the DVLED Wall-mount configuration?

The Cabinet installation order varies from the Floor Stand configuration. Please follow the steps in the respective order for the Wall-mount configuration: Cabinet C moved to the center of the installation position, and Cabinet B placed to the left side of Cabinet C Hex wrench used to help align and ensure no tile-to-tile steps before engagi...

How do I adjust the LED Module edge brightness on my DVLED Display?

When you find that the edge brightness of the LED module is different from that of the adjacent modules, the following procedure below can be followed in order to resolve the problem. Solution Step 1: Use the USB B-to-A cable and HDMI cable to connect the monitor to the computer, and switch the monitor's input source to HDMI. Step...

How do I set the DVLED Display to automatically update firmware?

Solution Step 1: Select the Settings from the Main Menu Step 2: Select "Upgrade" Step 3: Select "OTA Cloud Server" Step 4: Switch "Auto Updates" to on After turning on the automatic update setting, when the LED display is turning off, the automatic detection of firmware updates will occur. If the latest firm...

What is the Bracket installation order of the DVLED Wall-mount configuration?

The Bracket installation order varies from the Floor Stand configuration. Please follow the steps in the respective order for the Wall-mount configuration: Appropriate location and center point found for installation (e.g. upper bracket mounted at least two meters above the ground for a 135" LED display; for other display sizes, check corresp...

Where is the back hole location for where the system control power cable can pass through on DVLED Displays?

Refer to the schematic below for dimensions and approximate location of the power cable back hole. Note: HDMI/USB back hole configurations are displayed here, however, your current firmware may not support the HDMI back hole configuration.

How many sets of Ethernet and Power cables need to be attached to DVLED Cabinets?

Answer: The number of Ethernet and Power cable sets that need to be attached from the System Control Box to DVLED Display Cabinets will vary depending on Cabinet quantity. Please refer to this link to find the Cabinet quantity for the appropriate model. 

What is the Vacuum Suction Tool used for on DVLED Displays?

Answer: The Vacuum Suction Tool is used for removing LED Modules (or LED tiles) from the DVLED Display.  See "How do I remove LED Modules from the dvLED Display?" for more information on how to use the Vacuum Suction Tool.