Skip to main content

Why is my projector fan making an unusual noise?

Most fan noise issues are related to settings or ventilation. Check the High Altitude Mode and ensure the vents are clear before considering repair. Troubleshooting Steps: Verify Device Specs: If you own a fanless portable model and hear strange noises, contact support immediately as there are no moving parts intended to make sound....

Why are certain options greyed out in the OSD menu?

Certain menu settings are locked based on the current input signal or preset picture mode to maintain optimal image quality. Verify Input Source: When using digital connections (HDMI, DisplayPort), options like Phase or Horizontal Position are automatically optimized and locked. These are only available for manual adjustment under a VGA (a...

How to change the projector lamp in a projector?

The methods for changing the projector lamp (bulb) differ depending on the model of the projector. For accurate instructions, you can find lamp swapping instruction at ViewSonic product download page.   <Note> It is recommended that you use an authentic ViewSonic replacement lamp.  

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

How to play 3D content from Blu-Ray player to projectors?

1. Here are the hardware requirements to play 3D content below.     a. 3D ready projector     b. 3D Blu-Ray player     c. 3D content     d. Active 3D glasses 144Hz     e. HDMI Premium Certificate cable   2. Here is the playback process below.       a. Connect the 3D Blu-Ray player to the 3D capable projector via HDMI cable.       b. T...

How to fix the keystone effect (distorted image) on a projector?

Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust:   Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

How do I connect external speaker(s) to my projector?

1.Wired connection:   1.1 via 3.5mm audio out:       If the projector is equipped with a 3.5 mm audio out mini jack, usually it is  green and marked as          Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output        purpose.     1.2 via S/PDIF:        If the model is equipped with S/PDIF por...

How to change the projector image orientation (Flip or Mirror image)?

Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage.   2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

Projector Support

General Questions Technical Documents vRemote Tips & Tricks

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.