Skip to main content

How to setup and configure dual monitors?

Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...

Why does image persistence occur with my LCD monitor?

Image persistence (or image retention) is a result of a stationary image being displayed for a long period of time.    <Correction>   Turn off the screen for hours.   <Prevention>   1. Set the display to turn off after a few minutes of system idle under ”Power & Sleep “ (Win10) or “Battery” (Macbook).      2. Turn off the monitor when ...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion.   1.Adjust setting on the PC/laptop:   (1)Set native resolution of monitor in your PC/laptop's Display settings.   (2)Change Scaling in Display settings.   Use the graphic card software to change ...

How to restore the monitor to factory default settings?

Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...

Where to find serial number of the monitor?

The serial number can usually be found on the back or bottom of your product and is either 10 or 12 digits long. The serial number can also be found on the original box of the unit.

How to set power lock and menu lock?

On some monitors, there is a power button lock that locks the power and power button in the ON position.  There is also a menu lock feature which can lock and unlock the OSD (On-Screen Display) Menu.  Power Lock: To lock the Power Button press and hold both the [1] button and the down arrow button for 10 seconds.  OSD Lock: ...

Why my ViewSplit template is not being centered properly?

If you run into the templates not being centered properly, please follow the below steps:       1. Right click on the desktop icon of ViewSplit and Select “Properties”.    2.When the properties window pops up select the tab “Compatibility”. 3. Select “Change high DPI settings”.    4.Check the “Program DPI” box and the drop down “I op...

How to install the base on VX2476/VX2776/VX3276 series monitors?

You can refer to this video. 1. Lay the monitor unit face down on a flat surface, using the soft bag received or a soft material to avoid damaging the screen. 2. Insert and align the Neck of the stand (Do NOT attach the base to the neck) into the stand slot on the display. 3. Firmly push the neck into the slot while securing t...

Why can’t I run ViewSplit when connected to ViewSonic monitor?

Your ViewSonic monitor must be set to the Main display. To verify this please follow the steps below:     1. Right click on your desktop and select “Display Settings”.      2. Click on the display number at the top that you want to make the main display and check the “Make this my main display box” under Multiple displays.    3. If th...

LED Monitor Support

General Questions ColorPro™ (VP series)

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.