What is the function of power indicator in OSD menu on my monitor?

This is an indicator about power consumption ratio which is affected by some OSD settings change, ex. ECO mode and Brightness. Here's a matrix table about ECO mode and power consumption ratio. ECO mode Power consumption ratio Standard 100% Optimize 85% Conserve 70%

Why can’t I run ViewSplit when connected to ViewSonic monitor?

Your ViewSonic monitor must be set to the Main display. To verify this please follow the steps below:     1. Right click on your desktop and select “Display Settings”.      2. Click on the display number at the top that you want to make the main display and check the “Make this my main display box” under Multiple displays.    3. If th...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

What to do when the screen image is pixelated or blurry?

Blurry images are typically caused by an incorrect resolution or scaling setting. Ensure your computer is set to the monitor's Native Resolution. Troubleshooting Steps: Set to Native Resolution: Windows: Right-click desktop > [Display settings] > [Display resolution]. Choose the one labeled (Recommended). macOS: Go to [System Sett...

What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

Why does my TD2220 randomly receive touch signal and respond accordingly while exposed to sunlight?

TD2220 is an optical touch monitor which uses two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the sensor...

Why can't I choose Contrast or Brightness?

Certain preset modes (ViewMode) are factory-calibrated for specific visual tasks and will lock parameters to maintain optimal performance. Switch to [Standard] mode to regain manual control. Step-by-Step Instructions: Press the [Menu] button (located on the back or bottom of the monitor) to open the OSD menu. Navigate to the [ViewMode...