Direct View LED DisplaySupport - ViewSonic Mongolia

What are the power source requirement for DVLED?

Power Receptacle Type L5-30P, EU, UK, AU, CN (may vary depending on region. double check power supply compatibility) Power Input Voltage Range 100-240 V ~ 50/60Hz Input Current 30A max @110V; 15A max@220V Leakage Current <0.25mA@240VAC Power Outlet quantity 1 (for 108", 135", 163"), 2 (for 216") *Recommended use on a singl...

Why can't RS232 be used to Power on/off the DVLED Display while in Standby Mode?

Currently, RS232 cannot Power on/off a DVLED display while in Sleep Mode. Check the On-Screen Display (OSD) settings to see if the Standby Mode is set to Sleep Mode. Solution 1. To Power on/off a DVLED display using RS232, switch the Standby Mode in the On-Screen Display (OSD) settings to Hibernate Mode. 2. The DVLED disp...

Do ViewSonic DVLED displays support anti-blue light?

Answer: DVLED displays do not support anti-blue light at this time.

How do I remove LED Modules from the DVLED Display?

Solution Step 1: Wear anti-static gloves before handling the LED Modules. Step 2: Remove the Vacuum Suction Tool from the box and press its power switch to use it. Please charge it with the included power supply and make sure the vacuum suction tool is kept in a fully charged state. Step 3: Move the Vacuum Suction Tool to t...

Why is an entire column of LED Modules not on even though my DVLED Display is powered on?

DVLED Display with an entire column of unlit LED Modules. Answer: There may be poor connection or loose wiring with the connectors from the System Control Box to the LED Module adapter board. Solution The column's most bottom LED Module will need to be removed with the Vacuum Suction Tool in order to access the connectors. ...

How does ViewSonic ensure brightness uniformity for the LED pixels on a DVLED display?

Answer: The brightness of each LED is calibrated using a calibration software to attain brightness uniformity on the DVLED display. When LEDs from the factory are not calibrated, the brightness will be different across the display. A brightness calibration is recommended if there are differing levels of brightness.

What are things to be aware of when routing Ethernet cable through back hole on my DVLED Display?

Answer: The USB to RJ45 adapter needs to be independently purchased in order to connect the USB port to the motherboard. Cables should not be affixed too tight or have too much tension to avoid damage to USB cable and/or USB port

What tools are required for a dvLED Display installation?

Proper tools are essential for precise alignment and preventing electronic damage. The list includes measurement instruments, power tools, and mandatory ESD protection. Steps: Prepare tools according to the following categories: Measurement & Alignment Self-leveling laser level. Stud sensor/finder (multi-depth/material). 4-vial...

What do I do if there's damage on the DVLED flight case that I received?

Answer: If you are the recipient of the DVLED flight case, you must document any damage to the fight case onto the BOL (bill of lading). For information on potentially damaged or missing contents inside the flight case, please refer to "I'm a DVLED installer, but I need to ensure shipment corresponds with what is supposed to be provided. What a...

How many sets of Ethernet and Power cables need to be attached to DVLED Cabinets?

Answer: The number of Ethernet and Power cable sets that need to be attached from the System Control Box to DVLED Display Cabinets will vary depending on Cabinet quantity. Please refer to this link to find the Cabinet quantity for the appropriate model.