Skip to main content

How to check graphics card drivers in Windows?

1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.

Why is the "Auto Image Adjust" function grayed out in the OSD menu?

This is a feature, not a bug. When using a digital connection (HDMI, DisplayPort, or USB-C), the monitor automatically locks onto the signal with pixel-perfect precision, rendering manual adjustments unnecessary. Detailed Explanation: Digital vs. Analog Signals: * Analog (VGA): These signals may require "Auto Image Adjust" to correct ima...

How to setup and configure dual monitors?

Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...

Why is there touch response randomly on my TD2220/TD2421 even nobody touches the screen?

These models are optical touch monitors which use two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the se...

What to do when the screen image is pixelated or blurry?

Blurry images are typically caused by an incorrect resolution or scaling setting. Ensure your computer is set to the monitor's Native Resolution. Troubleshooting Steps: Set to Native Resolution: Windows: Right-click desktop > [Display settings] > [Display resolution]. Choose the one labeled (Recommended). macOS: Go to [System Sett...

How to restore the monitor to factory default settings?

Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...

How to set power lock and menu lock?

On some monitors, there is a power button lock that locks the power and power button in the ON position.  There is also a menu lock feature which can lock and unlock the OSD (On-Screen Display) Menu.  Power Lock: To lock the Power Button press and hold both the [1] button and the down arrow button for 10 seconds.  OSD Lock: ...

Why is my monitor emitting a high-pitched noise or buzzing sound?

Slight electronic humming is often normal (Coil Whine); however, persistent or loud noise may require environmental troubleshooting or technical support. Check Power Source: Plug the monitor directly into a wall outlet instead of a power strip to rule out electrical interference from other devices. Adjust Brightness: Try changing the b...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

LED Monitor Support

General Questions ColorPro™ (VP series)

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.