What to do when there is no display on my monitor?

Check the power LED first. If the LED is on but there's no image, the issue is likely related to the input signal or cable connection rather than power. Troubleshooting Steps: 1. Check the Power LED Status LED is OFF: Ensure the power cable is firmly seated and the physical power switch (if available) is turned on. Try a different wall out...

What should I do if there is no video signal when using the HDMI port?

Ensure the monitor is set to the correct HDMI input source and that the cable is firmly connected to the graphics card (GPU) output, not the motherboard. Verify Physical Connections: Unplug and re-seat the HDMI cable at both ends. Note: For desktop PCs, ensure the cable is plugged into the dedicated Graphics Card (GPU) port rather ...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion.   1.Adjust setting on the PC/laptop:   (1)Set native resolution of monitor in your PC/laptop's Display settings.   (2)Change Scaling in Display settings.   Use the graphic card software to change ...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

Why is my monitor emitting a high-pitched noise or buzzing sound?

Slight electronic humming is often normal (Coil Whine); however, persistent or loud noise may require environmental troubleshooting or technical support. Check Power Source: Plug the monitor directly into a wall outlet instead of a power strip to rule out electrical interference from other devices. Adjust Brightness: Try changing the b...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

Why does my TD2220 randomly receive touch signal and respond accordingly while exposed to sunlight?

TD2220 is an optical touch monitor which uses two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the sensor...

Why can't I choose Contrast or Brightness?

Certain preset modes (ViewMode) are factory-calibrated for specific visual tasks and will lock parameters to maintain optimal performance. Switch to [Standard] mode to regain manual control. Step-by-Step Instructions: Press the [Menu] button (located on the back or bottom of the monitor) to open the OSD menu. Navigate to the [ViewMode...

How to enable AMD FreeSync?

LED monitors produced after 2020 have FreeSync enabled by default. For LED monitors manufactured before 2020, please refer to the following instructions to enable FreeSync. To use AMD Freesync, there're some requirement with graphics cards, graphics drivers and certified monitors. 1. A compatible GPU with a DisplayPort connection. ...