Skip to main content

Does ViewSonic provide Linux drivers for monitors?

No dedicated driver is required. ViewSonic monitors follow VESA standards, allowing Linux to automatically recognize the display via EDID. Plug and Play: Simply connect your monitor; the Linux kernel will automatically detect the hardware. Adjust Display Settings: Navigate to your distribution's [Settings] > [Displays] to configur...

How to set the maximum resolution on your LED monitor?

Adjust the display resolution to the "Recommended" setting in Windows to ensure optimal clarity and eliminate black borders.   Adjust System Resolution: Right-click on the desktop and select [Display settings]. Under the [Display resolution] dropdown, select the value labeled [(Recommended)]. Disable Hardware Overscan: Press ...

Where to download ViewSonic monitor drivers for Win7 64-bits?

Please download the attachment and manually install the drivers under Win7 x64. File URL:https://support.viewsonic.com/helpdesk/attachments/33058629684

What to do if there is flickering image with my monitor?

Check the monitor: Please do memory recall. Please refer to this FAQ Check device setting: Please check and set to recommended refresh rate.  You can refer to this video. https://www.youtube.com/watch?v=sAkbjPiLNcE   If possible, please connect monitor to another device with different input.   If above doesn’t help, please contact ViewSo...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion.   1.Adjust setting on the PC/laptop:   (1)Set native resolution of monitor in your PC/laptop's Display settings.   (2)Change Scaling in Display settings.   Use the graphic card software to change ...

How to restore the monitor to factory default settings?

Use the "Memory Recall" or "All Reset" option within the monitor's OSD menu to revert all adjustments to their original state. Open the OSD Main Menu: Front Buttons: Press the button labeled [1] or [Menu]. Rear/Side Buttons: Press the designated menu button (refer to the icons on the bezel). Joystick Control: Press the center of...

How to setup and configure dual monitors?

Connect your cables, then use system shortcuts to choose between "Extend" or "Duplicate" modes and arrange the display order. Step-by-Step Instructions: 1. Fast Mode Switching (Windows) Press the Win + P shortcut. Select [Extend] to use both screens for different content (Recommended). Select [Duplicate] to show the same image on b...

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

LED Monitor Podpora

General Questions ColorPro™ (VP series)

General InquiriesKontaktujte nás

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.