Please refer to this FAQ.
Please check below: 1.Plesae refer to the user guide and adjust Aspect ratio with example below. 2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.
The projector's image size is determined by the distance between the projector itself and the screen. You can adjust the screen size by repositioning the projector, the image size and the distance needed will be shown in the projector user's manual. Some projectors also come with a zoom ring for the finer adjustment.
Make sure the signal cable is securely connected. 2.Try another video input source or cable or device to crosscheck. 3.Check the current resolution and refresh rate set in the graphic card or video source is compatible with the projector. You can refer to refresh rate setting video. How t...
1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.
After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...
Please connect the projector to a different AC outlet. Connect the projector to another computer/player. In case above crosscheck remains the same result, please contact ViewSonic service center.
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...
1.Wired connection: 1.1 via 3.5mm audio out: If the projector is equipped with a 3.5 mm audio out mini jack, usually it is green and marked as Audio Out. Please connect a 3.5 mm audio cable between speaker and projector for audio output purpose. 1.2 via S/PDIF: If the model is equipped with S/PDIF por...
Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.