Skip to main content

Why is the auto-pivot function not able to detect my monitor’s orientation?

Auto-Pivot requires DDC/CI enabled, OSD Pivot set to Auto, and the dedicated software running in the background. Troubleshooting Steps: Configure Monitor OSD Settings: Open the [Setup Menu]. Ensure [DDC/CI] is toggled to [On]. Set [OSD Pivot] to [Auto].                     Enable Control Software: Ensure vDisplay Mana...

How many monitors can I connect when utilizing the Daisy Chain connection on VP series?

 Please refer to below table:   Model Qty Native Resolution VP2468 4 1080P VP2468a VP2768 VP2768a VP2785-2K VP2771  VP2775 2 2*1440P 3 1*1440P+2*1080P  

How to disable Auto Pivot function under Windows 10?

You can set the Orientation setting to Landscape/CW90°/CCW90° or disable the “Auto Pivot” application.

Do VP series monitors support Apple Mac Thunderbolt connections?

Yes, fully supported. Every Apple Mac with a Thunderbolt port is designed to output a DisplayPort signal, ensuring 100% compatibility with ViewSonic monitors via the appropriate cable or direct connection. Compatibility Breakdown: Thunderbolt 3 / 4 / 5 / USB4 (USB-C Form Factor): Status: Fully Compatible. Mechanism: These ports ...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

What ViewSonic monitors can support Auto Pivot function?

As of Dec. 8 2020, below VP models support Auto Pivot function.   VP2458, VP2468, VP2468a, VP2768, VP2768a, VP2785-4K VP2768-4K, VP2785-2K, VP2771, VP2775, VP3268-4K.   Please refer to below steps to enable the function.   1.Download and install vDisplay Manager. 2.Follow UG for connection and setting. 3.Enable DDC/CI in monitor OSD to...

How to enable the input source auto detect function?

Please open the OSD menu and navigate into “Input Select”. Then, select Auto-Detect and make sure it is set to ON.

How to check the monitor’s current firmware version?

There are 2 ways:   1.On Monitor, please navigate to OSD -> Setup Menu -> Information, where you will see your current firmware version.   **For VP2468 versions M001 and M002, this function is not supported. If the firmware version is not present in the Information page, please update to version M010 or later.     2. On PC/Laptop, you ...

Why isn’t the monitor displaying anything after I plug in my DisplayPort input?

Please make sure to connect PC to the DisplayPort input instead of the DisplayPort output port on the monitor.    If your graphic card is capable of DisplayPort 1.1, please follow these steps and adjust monitor setting:   “Menu >> Setup Menu >> DisplayPort 1.2 Off”.

Why is my monitor not detected by the Firmware Update Tool?

Please make sure to use “FW_Update_Tool_v1.08”. Please follow the step by step instructions below to resolve the problem. When the program is initialized, the error message shown below will appear. A Windows error message might also pop up few seconds later. Please close the program and the error messages, then follow the in...

LED Monitor Support

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.