ProjectorSupport - ViewSonic Mauritius

What is the maximum resolution for the projector.

To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

There is no video when using HDMI port

If you are experiencing problems using HDMI input: Confirm the HDMI input is selected. Plug in the projector first, and then turn on the PC. Replace the HDMI cable, sometimes a cable may go bad. Try another signal type if available for example: VGA, DVI, DisplayPort. Test the projector on a different computer with a HDMI port to make sure...

Can I change the orientation of the projector when in use?

Please refer to user guide on page "Important Safety Instructions". Some projectors may be claimed to use at a limited angle dependent on the light source, such as lamp or LED.

Want to know about supported picture, video and audio formats

Each product has its own list of compatible video, audio and image formats. The best way to know what file type is specifically supported by your product is to look in the user guide for your particular model.

How to solve “Out of range” when connecting PC/laptop to a projector?

Please refer to this FAQ.

How to reset lamp timer

After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...

How to fix shadows, ghosting, or double images on the projector screen?

Image artifacts are often caused by poor cable quality or signal interference. Use high-quality cables and avoid using excessive adapters. Use Bundled Cables: Test using the [original video cable] provided with the product. Remove Intermediate Devices: Disconnect any [docking stations], [adapters], or [video splitters]. Connect the ...

Purchased replacement parts

Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/

Why the image is pixelated from my projector?

Usually this is related to unmatched output resolution setting and content. For example, setting 720P resolution output to a 4K projector or playing a 720P video on a 4K projector in full screen would cause pixelated. Please make sure to set recommended resolution by referring to this FAQ.