Skip to main content

How to fix ghosting, shadowing, or double images on the screen?

Image artifacts are typically caused by signal degradation or interference. Bypass any docking stations and use high-quality certified cables. Bypass Adapters/Docks: Remove any [Docking Stations] or [Video Splitters]. Connect the monitor directly to your PC to test the image quality. Upgrade Cable Quality: For long-distance connections...

How to do color calibration with my monitor?

Please refer to this FAQ, find "Calibrate your display" section and follow the instruction.

Why is there touch response randomly on my TD2220/TD2421 even nobody touches the screen?

These models are optical touch monitors which use two CMOS cameras (optical sensors) placed in the corners at the top of the screen as well as three reflectors (light strips). These cameras are used to look across the entire touch surface for touch events. When an object touches the screen, it blocks some of the light being received by the se...

How to solve the overscan problem with my monitor?

If the image does not fill the screen of the monitor or if it looks like the image is slightly too big for the monitor, try below suggestion.   1.Adjust setting on the PC/laptop:   (1)Set native resolution of monitor in your PC/laptop's Display settings.   (2)Change Scaling in Display settings.   Use the graphic card software to change ...

How to solve the problem with my monitor turning off automatically?

Automatic shutdowns are often caused by power-saving settings, inconsistent power supply, or signal loss. Please check the OSD timer settings first. Troubleshooting Steps: Check OSD Menu Settings (Most Common): Navigate to the [Setup Menu]. Locate [Auto Power Off] or [Sleep Timer] and ensure they are set to [Off]. Also, verify ...

What should I do if vertical or horizontal lines appear on my monitor?

Identify whether it is a "Hardware Failure" or a "Signal Issue." The quickest way is to open the monitor's OSD menu to isolate the cause. Perform the OSD Test (Crucial): Press the monitor buttons to bring up the built-in menu. Lines appear OVER the menu: This indicates a hardware/panel failure. Proceed to step 5. Lines are NOT on t...

How to check graphics card drivers in Windows?

1.Under "Control Panel", open "Device Manager". 2. Find the Display adapters and double click on it then double click on the device shown: 3.Select Driver tab, this will list the Driver version.

Why Your Monitor Mount Joint Might Be Stiff

The rotation axis of the Arm Hinge may feel tight or exhibit restricted movement. This is by design, as the axis incorporates a degree of resistance to help prevent the monitor from dropping, tilting, or moving unintentionally after installation. Before a monitor is installed or when the monitor’s weight is not applied, the rotation...

Which cable do I need to support a 144Hz refresh rate?

To achieve 144Hz, you must use the correct version of DisplayPort (DP) or HDMI based on your resolution. DP is the recommended interface for high refresh rates. Cable Requirement Table: Target Resolution Recommended Cable (or higher) Note 1080p (FHD) DisplayPort / HDMI 1.3 Supported by most modern cables 1440p (2K) DisplayPort 1.2 /...

Why can’t my monitor automatically detect a source?

The "Auto Detect" feature is disabled by default on many models. You must manually enable it within the OSD menu to allow the monitor to switch between active ports automatically. Step-by-Step Instructions: Press the physical button to call up the OSD Main Menu. Navigate to the [Input Select] section. Locate [Auto Detect] at the bo...

LED Monitor Support

General Questions ColorPro™ (VP series)

General InquiriesContact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.