ProjectorSupport - ViewSonic Myanmar

Why the image is pixelated from my projector?

Usually this is related to unmatched output resolution setting and content. For example, setting 720P resolution output to a 4K projector or playing a 720P video on a 4K projector in full screen would cause pixelated. Please make sure to set recommended resolution by referring to this FAQ.

There is no video when using HDMI port

If you are experiencing problems using HDMI input: Confirm the HDMI input is selected. Plug in the projector first, and then turn on the PC. Replace the HDMI cable, sometimes a cable may go bad. Try another signal type if available for example: VGA, DVI, DisplayPort. Test the projector on a different computer with a HDMI port to make sure...

What should I do if the projector remote control is not working?

Replace the batteries and ensure there are no obstructions between the remote and the projector's IR receiver. Replace Batteries: Insert a fresh set of batteries. Low power can cause intermittent operation even if the remote’s indicator light turns on. Clear Obstructions: Ensure the [IR Receiver] on the projector is not blocked by any ...

How to download the latest drivers for my projector

Option 1: Download from the ViewSonic Website Go to http://www.viewsonic.com/us/downloads_section/ Enter the Product Name, Product series and model number. Select the driver based on the operating system of your computer. Once the file downloads, double-click to open and start the installation. If you select Save, double-click on the downl...

What to do if there is spot on the projected image?

1.If spot is only visible when projected image in defocus, it would not impact usage. 2.If spot is visible when projected image in focus, please contact ViewSonic Service center for help.

How to fix the keystone effect (distorted image) on a projector?

Ensure the projector is level and perpendicular to the screen, then use the built-in "Keystone" settings to square the image. When you see below situation, please follow below instructions to adjust: Physical Alignment: Place the projector on a flat surface. Ensure the lens is at a 90-degree angle relative to the center of...

Purchased replacement parts

Parts can be purchased from our parts store. Go to https://www.viewsonic.com/parts/

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

Why does my projector automatically shut down during use?

Auto-shutdown is typically triggered by overheating protection. Ensure proper ventilation, clean the dust filters, and enable "High Altitude Mode" if necessary. Check LED Indicators: If the Temp light is red or flashing after shutdown, the projector has overheated. Improve Airflow: Keep at least 50cm of clear space around intake an...

How to adjust the image size on a projector?

Adjust the image size by changing the "Throw Distance," rotating the "Zoom Ring," or using the "Digital Zoom" setting in the menu. Adjust Throw Distance (Physical): This is the most effective method. Move the projector further from the screen for a larger image, and closer for a smaller one. Use the Zoom Ring (Optical): Rotate t...