How to make the screen fit my projector's display area?

Please refer to this FAQ:   How to solve the overscan problem with my monitor?

Why are certain options greyed out in the OSD menu?

Certain menu settings are locked based on the current input signal or preset picture mode to maintain optimal image quality. Verify Input Source: When using digital connections (HDMI, DisplayPort), options like Phase or Horizontal Position are automatically optimized and locked. These are only available for manual adjustment under a VGA (a...

How to change the projector image orientation

Use the "Projector Position" setting in the menu to flip or mirror the image according to your installation. Open Menu: Press the [Menu] button on your remote. Navigation: Go to [System Setting: Basic] > [Projector Position]. Choose Your Setup: Front Table: Default setup; projector on a table facing the screen. Ceiling: [Most...

What to do if the image is too dim from the projector?

1.Please increase the Contrast and Brightness in OSD menu.   2.Check the light source level and make sure it’s on Full or Normal.   3.Turn off or reduce environmental luminance where the projector is in use.

How to purchase a lens for a projector

Or browse to your projector model in the Projector Accessories section of the ViewSonic Store.  If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...

How to change the projector image orientation (Flip or Mirror image)?

Access the "Projector Position" setting in the system menu to adjust the image based on your installation (Desktop, Ceiling, or Rear projection). Open Menu: Press the [Menu] button on your remote or projector. Navigate to Settings: Go to [System Setting: Basic] > [Projector Position]. Select Orientation Mode: Choose the option that ...

Why a black border on the top/bottom or sides of the image from the projector?

Please check below:   1.Plesae refer to the user guide and adjust Aspect ratio with example below.   2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.

How to do when my screen doesn’t display native resolution after Windows 10 update?

Windows update may cause some issues with screen resolution setting being lost, Please follow below steps to change the resolution of the screen and check: Type Change screen resolution in the Search box from the desktop  and click   Change screen resolution of the display.   Under Display Resolution select Recommended resolution. A wi...

There is a pixel stuck on or off

Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...

How to set up dual projectors on a Windows computer?

Before connecting two projectors to your Windows PC/laptop, please ensure your system can run multiple video outputs. 1. To check your graphics card's maximum number of output signals, please refer to the graphics card manufacturer like the example below. Dedicate Graphics Card Integrate Graphics Card  2. Make sure your devi...