1. Connect the USB cable to the monitors USB Type B port on the back of the monitor and attach the other end of the cable to an available USB port on the computer. Allow 10-15 seconds for the computer to recognize the external webcam. Please do remember to connect the video signal cable between monitor and computer. NOTE: This method will ...
When resolution is set in native resolution (1:1), both Sharpness and Overscan option in OSD will be grey out.
You can refer to this video. 1. Lay the monitor unit face down on a flat surface, using the soft bag received or a soft material to avoid damaging the screen. 2. Insert and align the Neck of the stand (Do NOT attach the base to the neck) into the stand slot on the display. 3. Firmly push the neck into the slot while securing t...
MPRT and FreeSync are incompatible with each other because: MPRT will KEEP the refresh rate at a high and constant point. FreeSync will CHANGE the refresh rate continuously in a range between the minimum and maximum rate of the monitor. Therefore, all ViewSonic monitors that have MPRT(1ms) and FreeSync are not able to have both functio...
Please refer to the video on how to change: https://www.youtube.com/watch?v=sAkbjPiLNcE
Check the monitor: Please do memory recall. Please refer to this FAQ Check device setting: Please check and set to recommended refresh rate. You can refer to this video. https://www.youtube.com/watch?v=sAkbjPiLNcE If possible, please connect monitor to another device with different input. If above doesn’t help, please contact ViewSo...
1.If the line location is not fixed, please check and adjust firstly by following below methods: (1) Check the video cables and/or another video input. Make sure the cable is securely connected and if possible, change the cable. (2) Use another power outlet. (3) Connect the monitor to another computer. 2. If the line location is...
MacOS does not require monitor drivers when using a ViewSonic monitor. The MacOS will automatically read the EDID information stored in the monitor and use the system information/profiler utility to detect the monitor’s specifications and capabilities. If you can not get native resolution or refresh rate on the monitor: Please check if ...
To output: 1.1080p content at 144Hz, you will need either a dual-link DVI, a DisplayPort, or an HDMI 1.3 or higher cable. 2. 1440p at 144Hz, you will need at least an HDMI 2.0 or a DisplayPort 1.2 cable. 3.4K at 144Hz, you will need a HDMI 2.1 or a DisplayPort 1.4 cable which can carry 120Hz signal without compression.
If you are experiencing problems using HDMI input, suggest do the followings: Please check below on monitor: Make sure the correct HDMI input is selected in OSD. Turn on the monitor first then PC. Please check below on PC: Test the monitor on a different computer with a HDMI port. Replace another HDMI cable. If...