How do I adjust the overall brightness on my DVLED Display?

After replacement of a particular LED module, brightness may be slightly different than that of other modules. At this point, manual calibration is required. In order to troubleshoot this problem, the following procedure can be followed.


Step 1: Use the USB B-to-A cable and HDMI cable to connect the monitor to the computer, and switch the monitor's input source to HDMI.

Step 2: After the software is installed, open "AutoLED", select the "Calibration" tab, then click the "load data from module" button below.

Step 3: Turn on the LED display again, confirm that the value is successfully saved, and the problem should be resolved. It is recommended to conduct calibration as long as the LED module(s) are properly replaced, in order to ensure quality of the LED display.

Watch for instruction video: "How to do Module Brightness Calibration | ViewSonic All-in-One Direct View LED Display"

Last modified: Apr 2022

Direct View LED Display Support

General Questions

Contact Us

Contact Us directly if you’re unable to get the answers and solutions for your ViewSonic products.