Please check below: 1.Plesae refer to the user guide and adjust Aspect ratio with example below. 2. It could be the format of the movie since not all movies are formatted in 16:9. Some are formatted wider than 16:9 which will create black borders on the top and bottom of the screen.
Step 1 Download and install a Flash Player. “Download the Flash Player projector” from Adobe: https://www.adobe.com/support/flashplayer/debug_downloads.html Step 2 Input the URL of the Crestron interface in the Flash Player: http://[projector.ip]/CrestronUI.swf Where [projector.ip] is the ViewSonic projector’s IP address.
Or browse to your projector model in the Projector Accessories section of the ViewSonic Store. If a Long Throw lens is available for your projector, it will be listed on the online store. Note: A Long Throw Lens is not available for all ViewSonic projectors. To check availability, or to purchase a long throw lens, please contact ViewSonic...
To locate the maximum or native resolution for a projector, there are a few places this can be found. We highly recommend using the native resolution for LCD displays as this will provide the clearest possible image from the device. Check the product page for your model on the Viewsonic website and you will see the native resolution displaye...
Verify adapter plugged into a wall outlet Make sure the AC adapter is firmly and securely plugged into the wall outlet. Although it may sound obvious, the adapter can become loose without even knowing. If it's not plugged in all the way, it can make it seem like the adapter is not working, but it may just not be getting power from the wall...
If a fan begins to make a rumbling noise this may indicate a problem with the fan. Fans are essential to maintain optimal operating efficiency of the projector; so it is strongly recommended that the unit be sent in for service to replace the fan. If it seems like there is something hitting the fan blades it could mean that there is an obstru...
After replacing the Projector Lamp, resetting the lamp timer is highly recommended to help keep track of how long the lamp has been on. The Lamp Timer will also let you know when the lamp needs to be replaced. The Lamp timer can be found in the projector Menu. The specific location of the timer can be found in different locations depending ...
Make sure the signal cable is securely connected. 2.Try another video input source or cable or device to crosscheck. 3.Check the current resolution and refresh rate set in the graphic card or video source is compatible with the projector. You can refer to refresh rate setting video. How t...
Please connect the projector to a different AC outlet. Connect the projector to another computer/player. In case above crosscheck remains the same result, please contact ViewSonic service center.
Stuck or twinkling pixels on the projected image may be due to a defective DMD chip. These pixels can show up as bright, dark or twinkling points. They look similar to pixel defects on LCD displays. This cannot be fixed by the end user and must be sent in for service. Contact ViewSonic Customer Care to verify if your unit qualifies for warrant...